modeled up some brackets based off the originals , I adjusted to match 5.25 speakers. My brother was able to print them fine (Ender V3), passenger and drivers. Models attached below, note the model units was set incorrectly so they need to be scaled from 100% to 2540% to adjust mm to inches.
Note: Minor sanding will be required for an absolute flush finish with the panel, although its hardly noticeable. Black filament is recommended, as it will be visible through the panel.
| Attachments: |
|
3D Printed Bracket With Speaker.jpeg [ 95.53 KiB | Viewed 21616 times ] |
Bracket.zip [54.15 KiB]
Downloaded 649 times |