CTZCC.COM http://forums.ctzcc.com/ |
|
240Z 3D Printed 5-1/4 Speaker Brackets http://forums.ctzcc.com/viewtopic.php?f=7&t=10233 |
Page 1 of 1 |
Author: | Dat.240 [ Fri Oct 28, 2022 2:51 pm ] | |||
Post subject: | 240Z 3D Printed 5-1/4 Speaker Brackets | |||
modeled up some brackets based off the originals , I adjusted to match 5.25 speakers. My brother was able to print them fine (Ender V3), passenger and drivers. Models attached below, note the model units was set incorrectly so they need to be scaled from 100% to 2540% to adjust mm to inches. Note: Minor sanding will be required for an absolute flush finish with the panel, although its hardly noticeable. Black filament is recommended, as it will be visible through the panel.
|
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |