Welcome to the Connecticut Z Car Club Forums




Username:  
Password:  
Log me on automatically each visit
Register 
It is currently Thu Mar 28, 2024 1:15 pm
Welcome to the Connecticut Z Car Club Discussion Forums   
If you have trouble logging in or encounter any issues, please send an email to webmaster@ctzcc.com.

All times are UTC - 5 hours





Post new topic Reply to topic  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
PostPosted: Fri Oct 28, 2022 2:51 pm 
Offline

Joined: Thu Oct 13, 2022 12:40 pm
Posts: 11
modeled up some brackets based off the originals , I adjusted to match 5.25 speakers. My brother was able to print them fine (Ender V3), passenger and drivers. Models attached below, note the model units was set incorrectly so they need to be scaled from 100% to 2540% to adjust mm to inches.

Note: Minor sanding will be required for an absolute flush finish with the panel, although its hardly noticeable. Black filament is recommended, as it will be visible through the panel.


Attachments:
3D Printed Bracket With Speaker.jpeg
3D Printed Bracket With Speaker.jpeg [ 95.53 KiB | Viewed 19044 times ]
Bracket.zip [54.15 KiB]
Downloaded 633 times
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  









Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
mile200 v1.0.1 designed by Team -Programming forum- .