| CTZCC.COM http://forums.ctzcc.com/ |
|
| 280z r200 pinion flange wanted http://forums.ctzcc.com/viewtopic.php?f=6&t=7645 |
Page 1 of 1 |
| Author: | rob240z [ Sun Jul 14, 2013 8:16 pm ] |
| Post subject: | 280z r200 pinion flange wanted |
I'm trying to swap a 280zx r200 in my 240z. The pinion flange on the diff is not the size I need. I already have a driveshaft that I would like to use. I need the DAT-110 with 2.75 bolt circle. In the picture below it is the one on the left. I need the bolt too if you have it. Thanks, 
diff-flanges-2168 by Rob Olejniczak, on Flickr |
|
| Author: | rob240z [ Tue Jul 16, 2013 9:30 pm ] |
| Post subject: | |
I found one. Thanks, |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|