CTZCC.COM
http://forums.ctzcc.com/

I’m a trained professional don’t try this at home
http://forums.ctzcc.com/viewtopic.php?f=4&t=9408
Page 1 of 1

Author:  SurferD [ Tue Apr 10, 2018 4:58 pm ]
Post subject:  I’m a trained professional don’t try this at home

Thats what the body guy told me anyway. I never did listen, as my wife always tells me.
Here’s the start of floor replacement. That support really wanted to stay there.
Image

Author:  HowardJ [ Tue Apr 10, 2018 5:36 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

:shock: Holy (holey :wink: ) moly. Definitely a Flintstonemobile issue, requiring knowledgeable attention. Remember to add temporary bracing to hold body in proper alignment before cutting out/replacing any structural metal supports to prevent twisting. I wish you luck and success.

Author:  SurferD [ Wed Apr 11, 2018 2:59 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

Thanks Howard the front and rear edges of the pans are pretty much gone. I have plenty of bracing but I'm doing one side at a time and may not need it. I will need a straightedge setup when doing the inner/outer rockers.

Author:  HowardJ [ Wed Apr 11, 2018 6:18 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

:mrgreen: 8) :thumbs_up: :thumbs_up:

Author:  Frank T [ Wed Apr 11, 2018 6:27 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

Remember our member John who owns BadDog Parts in Mass; he makes entire floorpan and rail assemblies. Let me know if you forgot how to reach him.

Author:  SurferD [ Wed Apr 11, 2018 8:04 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

Frank T wrote:
Remember our member John who owns BadDog Parts in Mass; he makes entire floorpan and rail assemblies. Let me know if you forgot how to reach him.

I got the Zedd Findings floors/rails already.
I thought he did just rails. I actually like his rails better than Charlie's.

Author:  alllan71 [ Sun Apr 15, 2018 11:24 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

Same here; Zedd pans and Bad Dog rails...

Author:  SurferD [ Wed Aug 15, 2018 3:02 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

Finally got back into 777 in the past week after many months of sitting.
Floor is almost out and the inner rockers just have a few more welds to cut out.
New parts are patiently waiting.
It’s been at least 6 months since she ran. I wheeled her out and after 2 sets of cranks started up like it was a normal thing. I’m amazed at these engines.
Image
Image
Image

Image

Author:  FM6 [ Wed Aug 15, 2018 3:22 pm ]
Post subject:  Re: I’m a trained professional don’t try this at home

Nice to hear from you Rich and good progress :thumbs_up: :thumbs_up: 8)

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/