Sounds like you're progressing nicely.
.020 wire should be fine. I usually use .025 for sheet metal.
Make sure you stitch weld it so you don't deform the metal from the heat.
Post some pics
| CTZCC.COM http://forums.ctzcc.com/ |
|
| Replacing rockers, lower qtr dog leg, lower fend on '74 260z http://forums.ctzcc.com/viewtopic.php?f=15&t=8660 |
Page 1 of 1 |
| Author: | Harry Jukna [ Thu May 07, 2015 12:59 pm ] |
| Post subject: | Replacing rockers, lower qtr dog leg, lower fend on '74 260z |
Old rocker removed and replacement (Tabco) temporarily fitted. Replacements have extra metal at the top and bottom margins, assume grind this to fit after final fit & weld. Since I'm replacing rocker, lower rear qtr dog leg & lower rear front fender; assume need to fit and mock-up all pieces before final weld. Any suggestions and helpful hints appreciated. What's best welding wire size? Was thinking of .020 inch. Thanks - Harry |
|
| Author: | SurferD [ Thu May 07, 2015 7:02 pm ] |
| Post subject: | Re: Replacing rockers, lower qtr dog leg, lower fend on '74 |
Sounds like you're progressing nicely. .020 wire should be fine. I usually use .025 for sheet metal. Make sure you stitch weld it so you don't deform the metal from the heat. Post some pics
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|